Careful maintenance is required before or after using cutting machine,
which can prolong the service life of the auto cutting machine.
So how to maintain it?
This article will introduce this knowledge to you.
1. It is required to regularly remove the waste in the collection box to prevent too much waste from blocking the air outlet;
2. It is required to clean the cutting machine regularly every day, remove the sundries on the table, stopper and guide rail, and spray lubricating oil on the guide rail;
3. Clean the chiller regularly every half a month, drain the dirty water in the machine, and then replace it with new purified water;
4. The indoor environment will have a certain impact on the service life of the machine, especially the humid and dusty environment. The wet environment is easy to rust the reflecting lens, and also easy to cause problems such as circuit short circuit or laser discharge ignition;
5. The reflector and focusing lens shall be scrubbed with special cleaning solution every 6-8 hours. When scrubbing, it shall be scrubbed counterclockwise from the center to the edge of the focusing lens with a cotton swab or cotton stick dipped in the cleaning solution. At the same time, the lens shall be scratched carefully.
